Finished Project: Espar heater

[Paulus]

Thanks for all the input. I appreciate the pics.  The heater is installed and works great.  The hardest part was to drill a 4" hole in the port locker to install the new standpipe.  I did go with a closable vent in the head and a open one in the main cabin.
Also put high temp insulation around the duct work so that some of the radiant heat would not go into parts of the boat that did not need heating.
Thanks again for all the advice.
Paul

[Fuzzy]

Hi Paul:
Glad to hear that you got your heater all set up and working.  If you stop at Charlevoix again this summer when I'm around I would like to
see you again and your Espar setup.
Larry

[Stu Jackson]

    :pix:

[Paulus]

Will post a couple pics the next time that I go to the boat.
Paul

[Paulus]

Here are a couple of pics.
#1. aft cabin with air intake and also a access panel. Panel not installed yet.
#2. head with closable duct, also above the cabinet a "y" was installed, one duct going to the head and other to wet locker(our pantry)
#3. the open duct below the pantry door.