Messages

Hi Guys,

Thanks for all the advice.
Normally I'll see the boat again this weekend. I wrote down the things I have to look at and I'll post them as fast as possible.

The first thing I'll do is open the "engine room" and start following the wires from the altenator.
The boat is (as far as I could see) in very good condition, so I suspect to find the wires to go to the 1-2-B switch. But only one way to be sure ... :-)

I'll keep you informed :-)

Hi,

First of all, if this question is already answered or I created a duplicate thread, I apologise.

I just made an offer to a Catalina 34 (build 1992) (owner accepted it  )
It has a yanmar in it (30 hp I believe).

I read on the forum/wiki etc that for the Universal engine the harness should be replaced. Is this for the yanmar engines also?
Is it the same replacement kit?

Are there persons who have some tips/tricks about the harness and a yanmar engine?

thanks !!!
Pieter