How to Add a Secondary Starting Switch in the Engine Box
By Mark Elkin, Yorkshire Rose #133
When it comes to engine maintenance, I "single hand" a lot. I find it awkward, to say the least, to climb on the engine to get to the cockpit to fire the glow plugs and/or starter. My solution was simple: add another switch mounted in the engine compartment. I picked up a marine grade SPDT (mom-off-mom) at West Marine. Attached a couple wires (see the diagram) and I was off and running ....... ahem, make that "off and starting".
Important, make sure the switch can handle the amperage for this application. The starter solenoid is easily within the switch capacity. But directly powering the glow plugs would fry switch I used. Fortunately, this toggle switch can handle the Glow Plug Solenoid if that is installed. If not, you can alternately use 2 push button switches, same as up in the cockpit. Finally, make sure you use adequately sized wire: 16 gauge if just using solenoids, 10 gauge for directly powering the glow plugs.
![]() |
![]() |
Some notes:
- The Blue Sea #4154 (mom on / off / mom on) switch (@ West Marine, elsewhere) is rated 15a @ 12v. Glow plugs are rated @ 6a each. The Cole-Hersee #M-485 BP marine HD push-button switch (@ Defender) is rated 35a @ 12v.
- Wired per the diagram, the fuel lift pump isn't powered unless the key switch is left on (and alarm sounding,) so another toggle switch could be added if you want to run the pump / bleed the diesel lines. With that, the diesel can be stopped from below and not have to climb out to kill the alarm.
- Also, the switches need to be within 7" of the power source (e.g., solenoid terminal) or properly fused -- or the wire run be less than 40 inches long and placed inside a conduit or protective casing (ABYC.)
-- KWKloeber 1 December 2016