Rudder is soaked

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Mark Sutherland

I believe Gary Brockman recently bought a new elliptical rudder from Foss (in So. Cal) for about $1,900. 
Dunrobin II, 1986 C34 MK1 #170

Gary Brockman

Yes, I bought a new elliptical rudder from Foss Co. in Newport Beach last December as did Margie Woods for her race to Hawaii in the Single Handed Transpac. Both Margie and I can highly recommend the Foss Rudder which I believe was designed by Carl Schumacher as a replacement for the Catalina 34 and 36. The rudder cost $1,900 and I picked it up from the factory so there was no shipping charge.
Squall
1986 Hull #231
Tall Rig/Fin Keel - Elliptical Rudder
M25XPB - Flexofold 2 Blade 15x10
Marina del Rey, California

Noah

Did you have Foss machine/drill new post to fit your boat or use a outside machine shop?
1990 hull #1014, San Diego, CA,  Fin Keel,
Standard Rig

Gary Brockman

I used the local boatyard, Windward in Marina del Rey. I had the boat hauled out the morning I picked up the new rudder and the yard dropped the old rudder and cut and drilled the new rudder to match the old one. I think any good yard should be able to do the job.
Squall
1986 Hull #231
Tall Rig/Fin Keel - Elliptical Rudder
M25XPB - Flexofold 2 Blade 15x10
Marina del Rey, California

Mas Tequila

Well the death of my rudder was a bit premature. After some exploratory surgery I found that there was at some point some damage to the port side of the rudder and that it was repaired with what looks like nothing more than thickened epoxy and no glass. It seems that the repair was to an area about 4 inches in diameter and when it was faired basically to the base of the rudder. The repair cracked which allowed water to get behind it and run out of the crack and behind the faired area so water was running out at the base of the rudder. After a bit of grinding and drilling a number of holes I found much to my relief the core was dry and there was no signs of rust. Checked the rudder post and that is straight. Since it's to cold to do any glass work now I'm going to leave it open until the spring and re-glass it then.

Positive Latitude
1986 MKI hull # 11
Frankfort, MI

Noah

#20
What are you going to do with your new windfall (saved $2,600+!!)? How about a new sail!? :santa
1990 hull #1014, San Diego, CA,  Fin Keel,
Standard Rig

Mas Tequila

Noah, I'm thinking I'd really like a raymarine i70 wind speed depth system
Positive Latitude
1986 MKI hull # 11
Frankfort, MI

Noah

I like your positive attitude, "Positive Attitude". :thumb:
1990 hull #1014, San Diego, CA,  Fin Keel,
Standard Rig