throttle creep

[Jeff Kaplan]

finally got first sail in today. new rudder recently installed felt great, new elliptical style. moves a lot of water. wind died and we had to motor back. noticed that rpm's declining from 2,000 to a steady 1700. throttle up and a few seconds later, down. read a past post stating that inside the pedestal was a 9/16 bolt for friction. ron posted that it is on the starboard side. how visable is it and how far down. compass was just off so new chain/cable could be installed for the new quadrent for steering. no problem to remove again. all suggestions will be appreciated. thanks...jeff

[Stu Jackson]

look at www.edsonmarine.com

[Ron Hill]

Jeff : The adjusting nut is VERY visible.   Just look under the compass and follow the throttle shaft inside and you should find it. 
As a last resort you can also tighten the pivot or the double nut on the top of the governor.