Print

Please login or register.

[Holger Dieske]

... I need access to the 3 rear starboard bolts/nuts of the rail on the outside of the ledge. these are probably behind the closet in the aft cabin. Can I somehow remove the closet to access the hull/deck from the inside?

Holger

[LogoFreak]

Yes you can, but it involves removing the water tank, cutting out the shelf that’s tabbed in and then the aft hanging locker can be removed.

[kh3412]

I needed to reach the water fitting in the same area.
I just cut a round hole in the ceiling and closed off with a small port.

[waughoo]

I went in OVER my shelf for the rear water tank and got up to the deck fill for said tank so I could replace the fill hose.  This can be done without removing the closet "box".  Clearance is tight and if you drop anything, its a gonner between the liner and the hull.

[Ron Hill]

Holger : Is the genoa track that you are talking about in the recesses on the deck or do you also have a track on the top of the gunnel ??

A thought

[Holger Dieske]

....  on the top of the gunnel.

Holger

[Ron Hill]

Hogler : The only way you'll get to those nuts is to cut in a Beckson Port (screw in cap)

Personally, if I seldom moved the genoa car back that far, I just might ignore tightening them !!

A thought

[kh3412]

Hope this helps with placement of hole.
The three bolt holes you see in the second picture are the rear pulpit front stanchion mount.
Your bolts are about 6 inches in front.

[Noah]

KH- Hogler has a Mk1.5, which may be different??

[Holger Dieske]

I thank you for the information.

@Ron: I don't just want to tighten them, I want to put the base for arch (I think that's what they call it in English) there.

Holger