Join the C34 Association Today!
[C34 Home] [C34Tech Notes] [C34 Tech Wiki] [Join!]
Please login or register.
Advanced search  

News:

Pages: [1]   Go Down

Author Topic: Spacer corroded to chainplate rod  (Read 142 times)

0 Members and 1 Guest are viewing this topic.

NewToTheRoad

  • Forum - Petty Officer 3rd Class
  • ***
  • Karma: 0
  • Posts: 79
    • View Profile
Spacer corroded to chainplate rod
« on: May 27, 2019, 04:21:46 PM »

Hey guys.  Rebedding chainplates and find what seems to be an aluminium spacer corroded to the bar.  It made it quite difficult to unscrew the rod.  The other side was easy and the spacer freely moved up and down the bar.  Has anyone encountered this?  Is it a reaction of dissimilar metals - steel and aluminum? 

Thanks,
Bryan
Logged
Lori & Bryan
1988 C34, M25XP, Std Rig, Fin Keel - Hull # 697
Portsmouth, RI

Gregory M

  • Forum - Seaman
  • **
  • Karma: 0
  • Posts: 29
    • View Profile
Re: Spacer corroded to chainplate rod
« Reply #1 on: May 27, 2019, 04:34:57 PM »

Had the same problem when rebeding mine, only in those where leaking. I guess bit of water helps corrosion. I applied visegrips on spacer, rock back and forth.... loosen ... white powder came of.
Logged
Gregory, "Luna Rossa", #1063, 1990, T.Rig Mk 1.5, fin keel. Universal M 35,  Rocna 15,
Penetanguishene ON.

britinusa

  • Forum - Chief Petty Officer
  • ******
  • Karma: 4
  • Posts: 863
    • View Profile
    • Sailing Eximius
Re: Spacer corroded to chainplate rod
« Reply #2 on: May 27, 2019, 06:41:24 PM »

Same thing here.

FYI. before putting them back, I used a felt tip pen to mark the side that was visible when they were correctly oriented, made keeping them correctly oriented while tightening the rod.

Paul
Logged
Paul & Peggy
1987 C34 Tall Rig Fin Keel - Hull # 463

See you out on the water

Engine:M25XP

mdidomenico

  • Forum - Petty Officer 2nd Class
  • ****
  • Karma: 1
  • Posts: 113
    • View Profile
Re: Spacer corroded to chainplate rod
« Reply #3 on: May 28, 2019, 06:20:12 AM »

i had the same problem on four of my six rods and it was a real pain the butt to remove them.  two of them popped with a little persuasion.  one of them required vice grips above and below to twist the wedged washer free.  the last i had to resort to a blow torch to expand the aluminum and break it free.  when i reassembled, i slathered everything in lanacote, and i mean slathered, probably too much.  i'm not sure i understand why they're alu, but i suppose it's to provide a little give in the system.  a couple of mine were slightly misshapen.

Logged
1989 Cat34 #856, original MXP-25(ab?)
Pages: [1]   Go Up