A piece of 4" PVC pipe with a PVC end cap on one end, and a rubber cap on the other makes a pretty good storage container for small disposable type propane bottles. I drilled a hole in the bottom cap to release any propane that might be released from the bottle.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Main Message Board / Refinishing handrails
February 19, 2022, 07:50:47 AM
Instead of refinishing the teak handrails on the boat, and having to spend all the time taping and prepping, I thought there might be a better way. By installing a "T" nut on underside of the rail which locks the screw in place, you create an assembly where the screw won't turn or push up, thereby taking away the necessity of having someone backup the screw when reinstalling. I plugged the holes, sanded each plug flush, and varnished the rails while off the boat. Solo re-installation on the boat was a breeze, wrapped each protruding screw with butyl tape, slid in place, installed the nuts and washers, and tightened. No leaks! And if I ever have to remove the rails, no drilling and removal of the teak plugs, just remove the nuts/washers on the inside of the boat and lift off.
#3
Main Message Board / Rear seal oil leak
May 31, 2021, 10:44:26 AM
I have an oil leak which appears to be coming from the rear of the engine (M-25XP). It only shows after running the engine, and appears as a steady drip from the area on the back of the engine in the vicinity of the starter. I assume this is probably a lip seal issue? Question: can the seal be replaced without removing the engine?
I've searched the message board, tech wiki, and tech notes...just want to make sure...
1990 Catalina 34 1.5
I've searched the message board, tech wiki, and tech notes...just want to make sure...
1990 Catalina 34 1.5
Pages1