Join the C34 Association Today!
[C34 Home] [C34Tech Notes] [C34 Tech Wiki] [Join!]
Please login or register.
Advanced search  


Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - kh3412

Pages: [1] 2 3 ... 12
Since you're going to do glass work go ahead and drill into the block and see what you have. My boat was rotted and had to repair.,9208.msg67300.html#msg67300

Main Message Board / Re: Bigger boat
« on: May 01, 2023, 10:48:30 AM »
I also would have a mutiny on my hands. The 34 is quite possibly the perfect size boat, my point was I just want the hull of a 25

Main Message Board / Bigger boat
« on: April 29, 2023, 03:42:36 PM »
Who doesn't want a bigger boat.
We all suffer from two foot envy.
Oh the extra room.
Two heads.
 But then reality sets in for those of us in the north.
Paint the bottom, buff the side,and then wax them
Boy a Catalina 25 is sure looking good right now.

Just saying

Main Message Board / Re: Arch assembled :)
« on: September 30, 2022, 04:36:26 PM »
I am  very impressed, looks nice  :thumb:

Move heat exchange to rear wall to allow access to trans fill.

Main Message Board / Re: Aft cabin bolts Access
« on: July 18, 2022, 06:33:43 PM »
Hope this helps with placement of hole.
The three bolt holes you see in the second picture are the rear pulpit front stanchion mount.
Your bolts are about 6 inches in front.

Main Message Board / Re: Leaking Airmar knotmeter thru hull.
« on: July 14, 2022, 11:08:33 AM »
Had the same thing happen to me.
Had to order the spacer as the threads are not all the way down.
Hull thickness is right at the point you may or may not need the spacer.

Main Message Board / Re: Aft cabin bolts Access
« on: July 12, 2022, 07:10:05 AM »
I needed to reach the water fitting in the same area.
I just cut a round hole in the ceiling and closed off with a small port.

Main Message Board / Re: New Transmission
« on: July 12, 2022, 07:02:50 AM »
Did the twin disk install on my boat.
Yes I had to trim the port stringer but was not a big deal.
You cod do the install without trimming if your comfortable with your shifter being reversed I believe.
If you are interested reach out to me and we can talk.

Main Message Board / A/C install
« on: May 02, 2022, 08:07:47 AM »
Got the A/C installed and now I can retire :clap :clap :clap
Went with Flagship Marine because I wanted heat without using a heat pump.
It has resistive heat so I can have heat on the hard which the boat spends half the year on. 
Put it in the hanging locker by the chart table and used the macerator through hull as being on the great lakes
no overboard discharge.
Splashed boat in the snow 1 inch on the deck and got the boat up to 70 degrees.
Next weekend it was 85 degrees and had the boat down to 68 degrees.
It seems like a nice unit and it contains no printed circuit boards so will be easier to maintain.
have a great season all  :D

Catalina 34s Parts & Pieces For Sale or Wanted / Re: transmission
« on: May 02, 2022, 07:51:02 AM »
"bump" Still available

Main Message Board / Dana point
« on: November 10, 2021, 04:07:41 PM »
Any members at Dana Point, going out there and would love to get together for a drink and walk the docks?

Main Message Board / End of another season
« on: September 20, 2021, 12:54:34 PM »
Pulled the boat today that nasty white stuff is just around the corner.
What to spend the time before that to install my a/c unit.
Hope all you warm weather sailors enjoy your extended season.

Main Message Board / Re: C34 2002 transmission failure…what do I do?
« on: September 09, 2021, 11:15:42 AM »
I put a twin disk in and am very happy with the way it works. Did a write up of what it entails.

Pages: [1] 2 3 ... 12