Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - andre

#76
Main Message Board / Sherwood pump
November 02, 2018, 01:48:48 PM
Is there anybody who has remove the two bearings on the shaft of the raw water pump sherwood g908 and how to do that I think that there is a snap ring between the bearing. I see the snap ring on the picture of pump. Thank you.
#77
Main Message Board / Re: Sherwood pump problem
October 05, 2018, 01:42:06 PM
Thank you it's a good idea. In the same time I will practice my English
#78
Main Message Board / Re: Sherwood pump problem
October 04, 2018, 02:15:13 PM
Ok thank probably if I can't find the problem I will change for an oberdorfer model
#79
Main Message Board / Re: Sherwood pump problem
October 03, 2018, 04:56:03 PM
Ok but why when I turn the shaft the first ceramic disc don't turn . My snap ring is new. There is nothing for blocking the disc on the shaft. The first disc is supposed to turn on the other to form a seal.
#80
Main Message Board / Sherwood pump problem
October 01, 2018, 03:55:03 PM
I  clean and check my raw water pump but I saw something strange. When I turn the shaft only snap ring turn with and in fact the upper ceramic disc is suppose to turn the other disc to form a good seal against the water. When I check I don't see nothing for blocking the disc with the shaft. The snap ring turn on the flat copper washer and there is friction. Is it normal. I am not able to post the little video. why. Thank you
#81
Main Message Board / Re: Winter and shroud
October 01, 2018, 04:08:38 AM
Ok thank you guys. I don't touch nothing
#82
Main Message Board / Winter and shroud
September 30, 2018, 05:22:09 PM
Do you slack your shroud for the winter.. The temperature goes at -30 celcius often. Thank you
#83
Main Message Board / Re: Anchor saver
September 24, 2018, 02:08:14 PM
Thank you guys for all of your answer I will think of that this winter if I install something or not.
#84
Main Message Board / Re: Anchor saver
September 20, 2018, 02:42:03 AM
Do you have some photos about your system. My English is not very well and I don't understand your system with the shackle. I have a rocna 20 kg
#85
Main Message Board / Anchor saver
September 18, 2018, 03:53:53 PM
Is there anybody has a anchor saver to retrieve the anchor when she'is under a big rock. I lost an anchor in 40 feet of water and I hope that is my last time. https://youtu.be/4F5Xq15sGuc
#86
Main Message Board / Re: New noise near transmission
September 17, 2018, 03:28:48 PM
Thank you I will check for rent a rpm check instrument and adjust a little bit my rpm before to do something.w
#87
Main Message Board / New noise near transmission
September 17, 2018, 05:03:21 AM
Hello I have mk11 1997 with m35bc and a noise from the transmission at idle. The transmission works good and the question is how to know if the damper plate has a problem and can we hear that. Thank you from Montreal sailor.
#88
Main Message Board / Width and length of my wing keel
September 01, 2018, 11:09:57 AM
Does anyone know the width and the length of a wing keel for my c34 mk11 1997. Thank you
#89
Thank you I think mine is too low
#90
What's the best rpm at idle for a M35bc. Thank you.