Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Lance Jones

#31
Main Message Board / Re: Boom Lift Question
July 06, 2016, 08:23:44 AM
What about using the main halyard too? That's what I do. So the one going up has a jib and main halyard attached.
#32
Main Message Board / Re: Water in my bilge
June 29, 2016, 07:57:39 AM
Two comments. You said you noticed a small stream on the "PORT" side of the bilge. That would not indicate that as a hot water heater problem - Starboard side would. Also, is your boat in Salt or Fresh water? If it is in salt, dip your finger in the bilge water and taste it. If it is salty, the problem is not a fresh water leak.
#33
Main Message Board / Re: Macerator pump issue
June 14, 2016, 02:05:32 PM
Your output hose is on the top corner? Shouldn't it be in the lower corner?
#34
That looks good. I agree with Stu's comments.
#35
Main Message Board / Re: Broke down.
May 27, 2016, 04:38:35 AM
I'm out in the Gulf now. I'll look in my truck when I get back.
#36
Main Message Board / Re: Broke down.
May 26, 2016, 12:16:25 PM
Thanks all! The pump was installed and working great! Again you rock! BTW, the new pump part reflects that it comes w/of the return pipe attatched.
#37
Main Message Board / Re: Broke down.
May 22, 2016, 12:26:17 PM
Thanks Steve! I'll order it just in case!
#38
Main Message Board / Re: Broke down.
May 22, 2016, 06:04:00 AM
Thanks Paul. I used the m25xp to Kubota d950 manual on this site. The local dealer has the part number and will order it in the morning.
#39
Main Message Board / Re: Broke down.
May 21, 2016, 01:31:33 PM
Located a local Kubota dealer. Parts will be ordered Monday. Again, thanks.
#40
Main Message Board / Re: Broke down.
May 21, 2016, 10:06:17 AM
Thanks Ken. Yes. We were able to sail in. I figured out that you are correct. Does anyone know where to get one?
#41
We were motoring out when there was a squeal and the motor acted upon. Upon opening the compartment up there was water leaking from the circulating pump and it was not moving well when the motor was running.

Any ideas while I sit here at anchor?
#42
Main Message Board / Re: Thank you to Ron Hill
May 17, 2016, 06:39:05 AM
Without a doubt, Ron Hill is the Catalina Diamond of the C34IA forum. His compendium of knowledge, helpful hints, and overall willingness to help is second to none! For me, Ron has saved me thousands of dollars in repair cost alone. I nominate him for the C-34 Piece Prize!
#43
Main Message Board / Re: Asym/Cruising spinnakers
May 16, 2016, 12:41:25 PM
That it could!
#44
Main Message Board / Re: Asym/Cruising spinnakers
May 16, 2016, 12:29:12 PM
Thanks Braxton. It is probably too much trouble with my limited crew.  :shock:
#45
Main Message Board / Re: Asym/Cruising spinnakers
May 16, 2016, 10:26:31 AM
I have that for the symmetrical.