Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Bill Vensel

#1
Main Message Board / Re: Injector Pump Fuel Leak
December 25, 2016, 03:48:52 PM
Thanks, Ron. I'm sure you are right. I was using my metric wrenches for the job. A conversion chart shows the equivalent to be about 14 or 15 mm.
#2
Main Message Board / Re: Injector Pump Fuel Leak
December 25, 2016, 09:32:09 AM
I wasn't sure of the size before disassembly, and so I bought a package of a variety of sizes at West Marine, then matched up to the old ones. Turns out the 9/16" was the best match. So now I have a bunch of o-rings, some larger and some smaller in my locker. The pack was about $8.00, but I figured it not a bad idea to have some on hand.

Bill
C34 #980, Namaste
Charlotte Harbor, FL
#3
Main Message Board / Injector Pump Fuel Leak
December 24, 2016, 02:20:47 PM
This is my first post, and first of all, a big THANK YOU to you all for the great education you've provided.  I've been reading and searching the forum and tech notes,  and have found ideas, solutions and approaches to a variety of mechanical and electrical problems. So thank you to you all.

I resolved an issue that I did not see discussed, so thought I'd share here. Namaste has an M25XP.  I noticed fuel seeping out of the top of my injector pump. The high pressure fuel lines to the injectors connect to a part identified in the tech manual as the "delivery valve holder." It is a bolt like item that screws into the pump housing. It is hollow with a spring inside, the "delivery valve spring." No matter how hard I tightened it, fuel still made its way through the threads. On disassembly I found an o-ring at the top of the threads on each holder. It appeared that these rings had failed, and thus the leaks. I couldn't find any info on the rings, no part number or even size, but I found that a 9/16" ring fit perfectly. I replaced the rings on all three holders, reassembled, and no more leak. 

The tech manual did not show the rings, and I found them kind of by accident. Now it seems like a simple and obvious solution, but this amateur mechanic was stumped for a while. So I offer this for other amateur mechanics who might have a similar problem.