Messages

Kerk - you could try Swansmarina.ca the Ontario distributor for Catalina for a shipping cradle as Ron suggested, although most marinas here now require folding cradles for storage purposes.  The Marine Cradle Shop at 905 294 3507 would build you a new one.   Both of these companies are a good distance from Parry Sound which would add a shipping cost to your purchase.    Did you ask your marina if there was a local welding shop that could do this?  Quite frankly, I like Ron's suggestion not only for bottom painting but ease of transport (minivan?) should you change marinas in the future

Arnold Robart
Ten Times #1279

The A-B Coldmachine on our '94 when running works very well; however, it has developed a bad habit of occasionally not automatically re-starting.  Not good with a lot of frozen meat onboard.   I have to switch the breaker on the main panel off and on to get it going again which works every time.   The thermostat seems to be working ok and at a reefer mechanic's suggestion I replaced the main panel circuit breaker - no difference.  The compressor is under the cockpit and has a good supply of cool air.  Any ideas?

Arnold Robart
#1279 'Ten Times'

Dan
Check to see if you have some slack in your engine control cables and the wiring coming down from your pedestal.  My boat #1279 had enough to allow the water tank to be removed fairly easily.  Sure makes accessing the A-B a whole lot easier.

Arnold Robart
Ten Times
1994 #1279