I think you just had a loose injector causing all the carbon buildup. Did the engine sound kind of funny while running. I'd just make sure the valves adjusted right and injectors tight. Fire it up. It'll take a bit to clean out that one carboned up cylinder but should be fine.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Main Message Board / C30 tall rig mast wiring tracing
January 10, 2018, 09:56:57 AM
Our 1979 tall rig needs the mast rewired. We're going to drop the mast soon and ive been trying to trace where the wiring inside goes. It comes from the panel aft to in front of fuel tank area. Then heads forward. From there i lose it. Looked everywhere in bilge area, engine area, at mast base area, up around upper combing area. I've looked near mast post where it meets ceiling, nothing. Antenna ive found running on port side into head area, across at head level to mast post, then into post through small hole, about 3/4 in. I've felt inside hole and found nothing else. Can anyone tell me where Catalina might have ran these wires. We're going to be running all new wiring and I'd like to hook onto old wires to pull new ones through boat area.
Pages1