Messages

Greg, at the present time my boat is in the North Channel.  Will be going back tomorrow.  Would be glad to send you the # if you email me your phone number.  I had to come home and tend to some business.
Paul

Greg, Napa carries the facet fuel pump.  I bought my spare at Napa.
Paul

Nate, I sent you my phone #. I will be in Muskegon this morning and also Wednesday morning. I am finished with raising the boom and the sailmaker cut off a small part of the  bottom of the sail after measuring the sail.  Boat is docked in the north channel at present.  Needed to come home for business.
Will be returning on Wednesday to the North Channel.
Paul

Jim, I am leaving for the N. Channel on Thursday of this week.  Send me a personal email if you are still planning to go up north.  Maybe we could get together.
Paulus

Chuck,
I would read the message posted by Justin Steele.  One hole is for the automatic pump located in the bilge and the other for the manual pump.  I had a similar problem and found that the hose from the manual pump had a small crack in it on the bottom side just before it entered the thru hull.  Only leaked when I was under power. Something to look at.
Paul

Hope to see you in the North Channel.  One of my goals is to explore the south shore of Manitoulin and the Duck Islands, wind permitting. 
Paul

Cool Change going back into the water this spring, after long stay on the hard.  This was due to the illness of my wife.  I will be going back up to the North Channel.
Paulus

The engineering firm that does all the teak work for Tara Yachts had the teak and they also cut them to size and put the concave edge on each one. This firm is about 10 miles from my home.  I had used them before to make new eyebrows.

I believe it can be removed with a good wax remover(home depot).  For those of you old enough to remember the  60's and 70's, this was used to shine linoleum floors.  Looked nice but had to remove the old with wax remover and then put on a fresh coat.
Paul

Thanks Noah,
Appreciate the offer, but I need two as a match.
Found them at KnobDeco:  Sugatsune KB-50/s . 
Thanks again,
Paul

That would be great.  Email me to make arrangements.

Looking for 2 handles.  Have been looking around but so far no luck. Does anyone have a couple laying around or know were to find them. Happy to purchase them.  The screws measure 1 3/4" from centre to centre and about 1" tall.
Thanks,
Paul

Thanks for the info.  Ron, I did call the phone # you shared.  The phone works but no answer at the other end. I tried a few different times and also left a message.  Did find the the water strainer and bowl.  I also have the round o ring.
Thanks for the help.
Paul

Where did you find the new one?
Paul

Does anyone have a source for the sea water strainer bowl?  Looking for the bowl only.
Appreciate your help.
Paul