Catalina 34

General Activities => Main Message Board => Topic started by: crieders on December 23, 2021, 12:22:48 PM

Title: using cool new multimeter to check all engine components
Post by: crieders on December 23, 2021, 12:22:48 PM
any good article around about how to use a multimeter to check solenoids for starting motor, glo plugs, ground, starting motor itself? . Engine turns over with no umph; not enough energy to start the engine. Batteries do check out ok, even as to available cranking power.
Title: Re: using cool new multimeter to check all engine components
Post by: KWKloeber on December 23, 2021, 01:23:19 PM
Cliff

What's your basis that the batts have plenty of cranking power?

The glow plugs have zero to do with cranking.

I'd say first you need to understand what each part of the two starting circuits do, then you can check whether there's appropriate voltage at each key point/connection.
Or, if you search there's about a thousand message posts about what the critical things to check are, the vast majority don't need a meter (just inspection/cleaning/de-corroding/tightening.)  The one that really benefits from a V check is the key switch/S-wire circuit, and of course the V delivered to the solenoid B terminal while cranking.
Title: Re: using cool new multimeter to check all engine components
Post by: Ron Hill on December 23, 2021, 02:15:35 PM
Cliff : Take a look at all of your battery connections (clean? tight?), especially the #4 size negative wire that attaches to the engine bell housing!!

A few thoughts
Title: Re: using cool new multimeter to check all engine components
Post by: mark_53 on December 23, 2021, 10:41:35 PM
Do you have the OEM wiring?
Title: Re: using cool new multimeter to check all engine components
Post by: crieders on December 24, 2021, 10:33:59 AM
not sure. When I bought the boat, 30 yrs ago, I had a new wiring harness put in since there was a fire issue about the original.
its time to test the solenoids, the starting motor, the glo plugs, the ground, all the connections, the 3 batteries  . the battery connections look good and tight.
Title: Re: using cool new multimeter to check all engine components
Post by: KWKloeber on December 24, 2021, 11:16:22 AM
Cliff

You asked about slow turning over not long ago and there were significant discussions and suggestions about tracking that down??

https://c34.org/bbs/index.php/topic,11183.msg88980.html#msg88980
Title: Re: using cool new multimeter to check all engine components
Post by: Ron Hill on December 24, 2021, 01:57:59 PM
Cliff : I'm sure that you probably have the OEM wiring!.   IF YOU CHANGED WIRING - you would know it - so you should still have the basic OEM wiring.

All battery connections you say are clean and tight, but Did you check? that #4 ground going to the bell housing??  I ask because it is hard to get to and people forget about it!!

A thought
Title: Re: using cool new multimeter to check all engine components
Post by: mark_53 on December 25, 2021, 10:00:22 AM
Quote from: crieders on December 24, 2021, 10:33:59 AM
not sure. When I bought the boat, 30 yrs ago, I had a new wiring harness put in since there was a fire issue about the original.
its time to test the solenoids, the starting motor, the glo plugs, the ground, all the connections, the 3 batteries  . the battery connections look good and tight.
Put in a dedicated start battery and rewire so the main bank is charged directly by the alternator. The original wire harness is just not robust.  To many connections, under wire size, and length.