Hello All,
My long teak holly floor panel by the mast is rotted out from a former leak. With the long list of other $ consuming projects I have planned for 2016, I would like to fix this economically by splicing in a patch piece or scarfing in a piece.
Does any one have a small panel that they might have kicking around after they replaced panels that would be willing to part with? I will mail you a check for shipping and maybe a few extra bucks.
Thanks
Paul Barrett
I might be able to help. Where are you located?
Quote from: lazybone on January 05, 2016, 07:33:10 AM
I might be able to help. Where are you located?
I am in Salem Mass.
Quote from: Set2sea on January 05, 2016, 06:08:33 AM
Hello All,
My long teak holly floor panel by the mast is rotted out from a former leak. With the long list of other $ consuming projects I have planned for 2016, I would like to fix this economically by splicing in a patch piece or scarfing in a piece.
Does any one have a small panel that they might have kicking around after they replaced panels that would be willing to part with? I will mail you a check for shipping and maybe a few extra bucks.
Thanks
Paul Barrett
minimum size needed?
Paul : You might be better of asking one of the many boat yards is your area, if they have any teal & Holly sole scraps?
A thought
minimum size needed?
[/quote]
To play the minimum size safe, I would say 2ft sq would do it, Thanks
Quote from: Set2sea on January 06, 2016, 05:21:56 AM
minimum size needed?
To play the minimum size safe, I would say 2ft sq would do it, Thanks
[/quote]
Ok I put a shout out on the 30 list - we'll see.....
kk
Quote from: Set2sea on January 06, 2016, 05:21:56 AM
minimum size needed?
To play the minimum size safe, I would say 2ft sq would do it, Thanks
[/quote]
I have the center section that is about 3/4 thick. It sounds like you need the outer thinner stuff.