I am 3 hours away from my boat and need to make a plywood cover for the mast hole in the deck...the marina "temporary" cover always comes off before I get my tarp on. I have the material cut (a rectangle cover and a strip of wood for inside the cabin. I have an automotive gasket material to seal the plywood and will bolt thru the plywood to the strip of wood and "clamp" the cover in place) but misplaced my dimensions of the hole...max length and width. Does anyone have them? I couldn't locate in my partial manual and can't seem to get connected to the data base here....thanks
Chris
More Therapy
1989 Hull 945
Mast is approx 9"1/2 by 6"3/4...I measured inside dia of the bilge cover around the mast. I will check somewhere else for you if you know where to find demensions.
THANK YOU!