Catalina 34

General Activities => Main Message Board => Topic started by: Sundance on May 16, 2007, 09:55:08 AM

Title: Finding Hull #
Post by: Sundance on May 16, 2007, 09:55:08 AM
Where can I find my hull#?  It is not on the sails, I have the hull ID number from the title, but any idea what part of this is the "hull #" if any of it?  Just curious.
Title: Re: Finding Hull #
Post by: Steve Sayian on May 16, 2007, 10:11:39 AM
Jeff,

Typically it is molded into the Starboard side of the stern at or near the top.

On my '99 it is not molded in but etched (looks like by hand).

The factory also glasses into the hull in a difficult to find/reach spot the same number in case the boat is stolen.  Again on my '99 that 'secret place' is in the vee berth on the Starboard side of the hull just aft of the water tank.  It's yellow and about the size of a 3x5 index card.

Hope that helps.

Steve
Title: Re: Finding Hull #
Post by: Stu Jackson on May 16, 2007, 10:33:15 AM
And to understand what the #s mean, go here: http://www.c34.org/faq-pages/faq-hin.html
Title: Re: Finding Hull #
Post by: Sundance on May 16, 2007, 10:44:01 AM
Thank you.  I thought I saw something on this.  After checking, I am Hull# 844.  I'll add myself to the database when I get a chance.

Title: Re: Finding Hull #
Post by: Ron Hill on May 16, 2007, 03:30:49 PM
Steve : On a MKI with a standard transom, I also found the Cat # under the Catalina plate just under the teak step on the transom!!    :wink:
Title: Re: Finding Hull #
Post by: Steve Sayian on May 17, 2007, 03:36:21 AM
Ron,

That's interesting, because I thought the standard for marking was the starboard side of the stern (or gunwhale).  On all boats that I've owned from 1976 to now, that's where the numbers have been (Cape Dory, Tartan and Catalina).  Learned something new today.  Thanks!

Steve
Title: Re: Finding Hull #
Post by: Ron Hill on May 24, 2007, 09:43:46 AM
Steve : Your are correct on the standard marking location. 
Guess that the Catalina factory must have also marked the deck section so it would get mated to the correct hull# ??  :donno: