Engine driven pump hose part number

[prh77]

The pump that is driven by the alternator belt [fresh water ] has a hose that goes from 1" to 7/8" and has a pre-formed 90 degree bend. I can see " Gates "on the hose but no P/N. Has anyone purchased one from NAPA or where ever,and do you recall the part number? Also, the 7/8" hose that goes from the thermostat housing to the coolant reservoir, will a regular hose make the bend with-out crimping, or do I have to go pre-formed. Thanks all.

[Mike and Joanne Stimmler]

I was able to use a wire reinforced hose when I replaced mine, but there may be a preformed hose available.

[Ron Hill]

Payton : I took mine off (the previous engine) and went down to an auto parts store and was able to match it with an auto preformed hose. A thought