Sink Drain Project Advice

Previous topic - Next topic

0 Members and 4 Guests are viewing this topic.

Lance Jones

I have all the major parts to redo the sink drain system as is mentioned in the project section. Also, with my gnu access panel I installed, this project should be easier due to the increased access. Now my question..... As I mentioned a long time ago, the nipple coming off my through hull does a 90 degree bend. My first task is to replace this with a straight nipple (OK Stop the visualization! :roll:). Once I get it out, what is the preferred type material to replace it with? I've seen PVC, Brass and any number of types at Home Depot and West Marine. Look forward to getting this done and having a speedy drain!
Lance Jones
1988  C-34 Kitty's Cat
S/N 622

steve stoneback

Steve Stoneback
Grasmere
1989 #918
Lake Oahe Pierre, SD

Lance Jones

Thanks Steve. Any particular reason? (Just asking)
Lance Jones
1988  C-34 Kitty's Cat
S/N 622

steve stoneback

Lance,
I am sure a PVC one would have worked too, I just wanted something a little stronger below the waterline.
Steve
Steve Stoneback
Grasmere
1989 #918
Lake Oahe Pierre, SD

Stu Jackson

Lance you only have 2 choices below the waterline and plastic is not one of 'em.  Use either Marelon (which is what the thru hulls are made of) or bronze.  I would NOT use brass on a boat, ever!  The reason is galvanic corrosion which eats brass up right away - some research on different metal materials is recommended if you haven't done so already.
Stu Jackson, C34 IA Secretary, #224 1986, "Aquavite"  Cowichan Bay, BC  Maple Bay Marina  SR/FK, M25, Rocna 10 (22#) (NZ model)

"There is no problem so great that it can't be solved."

Lance Jones

Lance Jones
1988  C-34 Kitty's Cat
S/N 622

steve stoneback

As always, Stu is right and it was bronze I used and not brass.  I am not sure they even make that big of a brass nipple.  I do remember it cost about 12 to 15 bucks.
Steve
Steve Stoneback
Grasmere
1989 #918
Lake Oahe Pierre, SD