Dimensions for space under table in MK1?

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Bill Shreeves

If anyone happens to be aboard their MK1, any chance you could get approximate dimensions of the space aft of the table post?  I'm wondering if a dog crate might fit in that space temporarily.  Ideally, dimensions fore and aft between table base and cushions projecting forward and starboard cushions to port side of table and height between sole and table supports.

Thanks if anyone can share that!

-Bill
The only thing that always works on an old boat is the owner...

Bill Shreeves
s/v "Begnnings" 1987 Shoal Draft #333
M25XPB, Worton Creek, MD

ErikN

On my boat,
Fore-aft: 13"
Starboard-port: 24"
Sole-table support: 26"

The table base is fairly wide and uses up quite a bit of the fore-aft space. Also, the aft edge is not perpendicular to the starboard edge, so the space is narrower at the starboard end. The numbers above are approximately the smallest rectangle that would fit. I hope this helps,
Erik
Erik Noonburg, Seattle WA
#53 1986, SR/FK, M25, "Callooh! Callay!"

ErikN

Oops, I meant the *largest* rectangle that would fit (based on the narrowest part of each dimension).
Erik
Erik Noonburg, Seattle WA
#53 1986, SR/FK, M25, "Callooh! Callay!"

Bill Shreeves

The only thing that always works on an old boat is the owner...

Bill Shreeves
s/v "Begnnings" 1987 Shoal Draft #333
M25XPB, Worton Creek, MD