Valve adjusting m25xp

[glennd3]

I just adjusted the valves on my m25xp. All the info is on this site. Job was easy and straight forward. 10 mm wrench for lock nuts, 12 mm wrench for valve cover nuts, feeler gauge and I turned the engine by turning alternator. The valves were all a little loose. I also replaces the valve cover seal because it was leaking a little in the back and I did not know it's age. I was also happy with the appearance of the valve train, clean and not worn from what I could see. 2500 hours

[Ron Hill]

Glenn : Good for you, an easily done task on the M25X, because the markings are on the flywheel!!

A thought