Wiring Diagram with 4 6v golf cart batteries and starting battery on Luna Loca

From c34.org
Revision as of 13:05, 6 May 2010 by Ken juul (talk | contribs) (New page: Basic Design Given that I know we are energy hogs that do a poor job of conserving batteries I went with a system that is large enough to get me through a day of sailing and a night at anc...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Basic Design Given that I know we are energy hogs that do a poor job of conserving batteries I went with a system that is large enough to get me through a day of sailing and a night at anchor without charging; normally staying above 50% discharge. It was also important to me to have a totally separate starting circuit. Losing the Autopilot, chart plotter, radar due to low voltage caused by starting the engine is not good for the electronics and scares/confuses the hell out of any guests that may be driving the boat. Normal switch positions. Main battery switch is in 1. Start battery switch is “on”. Batteries House: 4- 6v golf cart in battery locker under settee in front of galley sink. Start: 1 -12v Group 24? Mounted under aft bunk, in prop shaft access space.

Charging

Xantrax True Charge 20 (yellow unit) mounted under Navsta desk. Separate charge circuits to each battery bank protected with circuit breakers. Powered by shore power or Honda 2000. Engine. OEM 55 amp internal regulated alternator wired to house bank. Start battery charged through a Blue Sea Systems Starting Isolation (SI) Dual Sensing Automatic Charging Relay. Monitor XANTREX LinkLITE mounted under cabinet (with sliding doors) above electrical panel.

Battery Cables Existing cables if reused had connections replaced. Crimped, Soldered, Sealed. Positive cables. House Bank to Battery switch position 1. Start battery has new On/Off switch located on engine bulkhead in aft cabin. Wired direct from switch to starter, then to Battery 2 for emergency use. Negative cables. House bank to engine. Start battery to engine. House loads from panel to engine and house bank neg bus. Used existing cable runs when possible. New cables go under cabin sole, under the head sink then between muffler and engine bulkhead to rear of engine. Straighten two wire coat hangers and taped together to snake cables under the sole.

Diagram