Heat Exchanger Pictures

From c34.org
Revision as of 17:14, 18 August 2010 by Ken Juul (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Diagram and instructions from Sendure. One of the sources for new end caps and gaskets.

Sendureendcaps.jpg

Picture of HX, partial disassembly of end cap.

Hx1.jpg

Picture of inside of HX. This is the pencil zinc end, it screws into the hex shaped fitting at the 1 o'clock position. When installed it fit in the cavity before the small cooling tubes start.

HX2.jpg

Picture of destroyed impeller bits taken from pump output and heat exchanger.

Hx3.jpg

Picture Credits: I did not take any of these pictures, they were copied from posts on the forum. Thank you to the contributers.