V-Berth Cushion Insert

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

rmbrown

Does anyone have a picture of the v-berth cushion insert in place in the lower position, as a seat?  I'm going to cut a shelf to fit there and I'm wondering if I can make it out of something 13" deep rather than 14" (because I have a piece of mahogany that would look nice) but I want to be sure that it will be adequately supported.
Mike Brown
1993 C34 Tall Rig Wing Keel Mk 1.5
CTYP1251L293
Just Limin'
Universal M-35AC

Stu Jackson

Top seems pretty close to the bottom of the drawer frame.
Stu Jackson, C34 IA Secretary, #224 1986, "Aquavite"  Cowichan Bay, BC  Maple Bay Marina  SR/FK, M25, Rocna 10 (22#) (NZ model)

"There is no problem so great that it can't be solved."

Noah

The "trick" is to stop it from sliding/falling out of position. Lots written about that, I recall? I used two slide bolt underneath to "lock it" into holes I drilled into the gelcoat for the down position and the teak support rails for the up position. Still a bit of a PIA to line-up and lock.
1990 hull #1014, San Diego, CA,  Fin Keel,
Standard Rig

rmbrown

Mike Brown
1993 C34 Tall Rig Wing Keel Mk 1.5
CTYP1251L293
Just Limin'
Universal M-35AC