Join the C34 Association Today!
[C34 Home] [C34Tech Notes] [C34 Tech Wiki] [Join!]
Please login or register.
Advanced search  

News:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Mike and Joanne Stimmler

Pages: [1] 2 3 ... 57
1
Main Message Board / Re: macerator pump
« on: September 22, 2018, 10:05:38 PM »
I think you'll need to buy a new one, Mark

Mike

2
Main Message Board / Re: Fuel Tank Replacement - Plastic?
« on: September 14, 2018, 01:26:54 PM »
Maybe you should check to see if it's repairable. The places that make custom tanks could probably tell you.
BTW I had a '89 Catalina and never a problem.

Mike

3
Main Message Board / Re: San Diego slips
« on: June 11, 2018, 03:01:24 PM »
If you like Mission Bay, Marina Village is pretty Nice. I was there for Five years and was treated well.
It's been awhile since I was there but at the time we were paying about $500 per month.
It's about a four hour sail to get to the SD main harbor since you have to go off shore a bit to go around the kelp beds at the point.

Mike

4
Main Message Board / Re: NavPod tool
« on: June 02, 2018, 03:37:59 PM »
I'm assuming the tool you're talking about looks like an allen wrench with a hollow center. Does that sound right? When I bought my nav pod it came with the allen wrench type tool but I think it also came with a straight one that you could put in a drill chuck. I also was able to fine a tool in my box that worked with a screw driver type handle. It is a tool that I used when I worked for Bell Telephone and is made by Stanley and has a KS-19192 designation number on it which is a bell tell designation so I don't know if that will come up on the net or not. Hope that helps. You could try Harbor Freight of Sears.
Mike

5
One advantage of having two shut off valves is that you can fill both tanks from the aft tank if both valves are open and you can also leave the aft tank full  and then fill the stbd tank when it runs out.

6
Main Message Board / Re: Water Filter
« on: January 13, 2018, 10:59:13 AM »

I bought a whole house water filter at Home Depot and adapted it to connect to my hose from the dock. It worked out pretty well.

Mike

7
Main Message Board / Re: Youtube Video of C34 Survey
« on: December 13, 2017, 10:40:23 AM »
Do you know of any 34's that have done the "Bash" back up north? I've done it twice on other peoples boats and it's not too bad if you're not in a hurry and keep an eye on the weather reports and carry extra fuel.

8
Main Message Board / Re: Raritan PH Superflush Head
« on: July 25, 2017, 07:03:03 PM »
And don't forget that vented loop in the water supply.

9
Main Message Board / Re: gps mount on pedestal question
« on: June 09, 2017, 02:08:25 PM »
Here's an idea for you


10
Main Message Board / Re: Centek Vernalift Muffler.
« on: May 30, 2017, 11:32:24 AM »
Stu, I don't know if they have them but I've always had better luck with parts and better service with Catalina Yachts than Catalina Direct. They just seem to go that extra mile when you need it. I would defiantly try them and their prices seem to be better too.

Mike

11
Main Message Board / Re: Dual Tank Propane Locker
« on: March 24, 2017, 04:08:25 PM »
Did you or can you leave enough slack in the hoses so that they could be swapped in case one tank runs out?

12
Main Message Board / Re: Dog on board?
« on: December 07, 2016, 11:20:20 AM »
Have you looked at the dog ramps made for use with Pick Up trucks?

Mike

13
Main Message Board / Re: Removing rusted nuts using a candle and a lighter
« on: November 12, 2016, 09:04:20 AM »
I apologize for all the commotion I caused with this post.

Mike

14
Main Message Board / Re: Removing rusted nuts using a candle and a lighter
« on: November 08, 2016, 11:50:37 AM »
I would think that someone would come across a rusty bolt or two on a diesel engine if not a lug nut.

15
Main Message Board / Re: Removing rusted nuts using a candle and a lighter
« on: November 08, 2016, 08:11:42 AM »
And it must have worked perfectly cause you're still alive.

Pages: [1] 2 3 ... 57