Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Scornell

#1
Fleet 12 / Re: Catalina Fleet 12
March 03, 2018, 07:30:55 PM
I recently acquired a1989 C34 which is right now on the hard at Flag Harbor, just north of Solomons. Would be happy to be kept in the loop of any Chesapeake fleet activities. Trying to get her ready for the water by late April!

SC
#2
Main Message Board / Re: Leaks: Cabin sole wet
November 15, 2017, 05:51:23 AM
Quote from: britinusa on November 14, 2017, 01:13:52 PM
Any chance you can have someone spray water on the deck around the mast and hatch while you inspect from below for leaks?

Yes. That is the plan once I get someone to assist and weather cooperates. Thanks.
#3
Main Message Board / Re: Leaks: Cabin sole wet
November 14, 2017, 12:23:34 AM
Thanks. Very useful ideas. Will check it out. And yes, I will definitely take care of the chainplates before the boat goes back in the water. It is on the top of my list, along with little details like putting double clamps on all thru-hulls!
#4
Main Message Board / Leaks: Cabin sole wet
November 13, 2017, 02:15:41 PM
Hi,

New to the Forum and to Catalina 34! I got my 1989 C34, Hull 872 if I read it correctly, just last week and trying to bring it back to shape. This Forum is immensely helpful, as I will try to chase down a few leaks. The small leaks from the chainplates don't worry me much. But when it rains, a pool of water forms on the cabin sole to port of the keel-stepped mast and aft of it. I can scoop up half a cup of water or more. The bolts near the mast in the ceiling  are wet, and the opening hatch appears dry.  But I wonder, if it comes from the mast, why would it not run down the bilge, how would it get over the lip around the bilge? The picture below shows what it looks like after a night's rain.

Less visible is that there's a little bit of water at the base of the cabin table. So, water on both sides of the bilge - and yes, the PO replaced the floor boards right over the bilge so this may have been going on for a while. But weirdly, those narrow middle boards are pretty dry.

Before I chase it down, I thought to check if anyone has had this problem. All ideas are welcome. Thanks for a great community.