Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - JCHoctor

#1
I am getting into the boat and trying to address some issues that I know I should have paid more attention to in the past couple of years but the simply I can not change what I should have done only accept responsibility for it and move forward - right? 

I am looking at the shaft and stuffing box (repacking the box was on my list) but as I see the shaft I am concerned about this white build-up on the shaft.  I have not had a chance to actually handle it but will be doing that this weekend.  My question to the community is how bad is do you think?  I am not experienced with the drive train and the boat is in the water so if I need to replace it I would need to pull her

I have read through some of the threads but do not see any that relate to what I am seeing (Sorry if I missed something) so I am hoping for a little support from the community and some honest thoughts about how bad this appears. 
#2
All looking to source the local wisdom of the group. 

I have come by a new to me slightly used Genoa that came off a C34 mk1 just a few boats after mine in production order but it appears that the length of furlers were not the same on our two boats.  I raised the sail only to find that I am about 6" to a foot off.  I will verify my sail area today. 

What I am curious about is if I have any adjustment I can make in my system to either lower the drum or take or some at the top with the swivel? I am hoping to avoid having to cut the sail since that would (combined with the cost of the sail) put me into a place where I could have reached to a new genoa - need to save face with the spouse - I am sure a few of you know the drill. :)

Thanks in advance, John