I had water leaking in on the port side at the holding tank vent stanchion. I rebedded the stanchion with butyl tape several years ago and I thought the leak was from there. Upon inspection, I now think it is coming in by a bolt to the right and below the stanchion. Can anyone tell me what the bolt is for and where the head is as I see several more to the left in the compartment. Could it be to attach the rub rail? I know that where a leak shows does not mean that is where the water comes in.
Not sure I will like the answer but thanks as always thanks for your suggestions.
HI,
If you are talking about the bolt that goes on the side of the hull, yes they're from the jonction of the deck to hull and hidden outside by the rubrail.
if the bolt you see is vertical ( pointing down) than its from the headsail car track
Jim : Are you talking about a nut? or a bolt?
Very possible, if what you see is a horizontal bolt, that is from the rub rail track. Take a look at the bolts in the v-birth and under the trim above the salon seating and see if they are the same.
Ron
What I am seeing is the thread and a nut as if the head is outside of the hull. It is not vertical. If the head attaches the rub rail, I don't see how it would show a leak when running water on the deck. It is possible that I did not check the vent stanchion bolts carefully and one or more is leaking, again. I looked carefully at the scupper and do not see any cracks. Of course, there could another explanation.
Hope to see you and Phyllis at the Fleet 12 Fall Meeting in September.
Quote from: Jim Brener on August 23, 2014, 04:23:06 PM
Ron
What I am seeing is the thread and a nut as if the head is outside of the hull. It is not vertical. If the head attaches the rub rail, I don't see how it would show a leak when running water on the deck. It is possible that I did not check the vent stanchion bolts carefully and one or more is leaking, again. I looked carefully at the scupper and do not see any cracks. Of course, there could another explanation.
Hope to see you and Phyllis at the Fleet 12 Fall Meeting in September.
This is where one says, "A picture is worth "X" words" when trying to get someone to identify a strange appurtenance. Especially on a sailboat!
:donno:
kk
Jim : The vented stanchion bolts could be leaking from the water from washing the deck and dripping/running down on to that nut/bolt end.
The water could also be coming thur the bolt that hold the rubrail channel ??
Run some water on the deck and then take a piece of Kleenex and touch the 4 bolts that hold the vented stanchion in place and if it shows no water touch the Kleenex to that nut / exposed bolt end. Good Luck
A thought