I want to replace the seal on my Lewmar low profile hatch. I removed the covers on the hinge pins and I understand each aluminum pin should slide to the center to release the hinge, but there's a bit of plastic in the center that keeps this from happening. I don't see how I can open the plastic. What am I missing?
Thanks in advance for you assistance.
Tom : I believe that you have a Lewmar quest that can be answered by them!! try "USTechsupport@Lewmar.com"
A thought
Ron,
Thanks. Lewmar was very responsive, but unfortunately they gave me the wrong information. Since the rigid boom vang restricts the hatch, it's difficult to get a good view and my picture was not clear. Under better light I was able to see the plastic clips and pop them off.
After a few minute soak in PB Blaser, I had the lid off and was able to clean the gasket, hopefully fixing the leak. If not, I will replace the gasket.
Here is the type of hinge on my hatch: